Mushkin 1GB XP4000 2-2-2 REDLINE Dual Pack
July 12, 2005
Manufacturer: Mushkin
Introduction
Overclocking at low latency has always been the target of most enthusiasts. We all know that running the memory at extreme timings will boost your system’s performance significantly. However, with overclocking, most of the time we have to sacrifice latency over speed. That has changed recently with the rebirth of Winbond’s BH5 in the form of UTT chips.
Mushkin was one of the first few memory manufacturers to take advantage of these chips. With the ability to run at ultra low latencies using high voltages at fast speeds, UTT chips offer the best of both worlds for the ultimate enthusiast. Today, we are gonna be looking at one such product from Mushkin. Introducing, the 1GB XP4000 2-2-2 REDLINE Dual Pack.
How does Mushkin describe the 1GB XP4000 REDLINE Dual Pack?
“The XP4000 REDLINE eliminates the memory as a potential bottleneck when overclocking. THE REDLINE MEMORY MODULES ARE DESIGNED TO RUN AT HIGHER VOLTAGES UP TO 3.5V AND SUFFICIENT COOLING IS A REQUIRED. Active Cooling Required *----Due to the extreme speed of these modules along with the added voltages used, Mushkin requires end users to Actively cool their memory modules. Modules that are not properly cooled will/may not meet rated timings and speeds, and may become susceptible to premature failure. We generally recommend 15-25cfm of direct airflow over the ram modules which can be easily accomplished with one 60mm or 80mm low rpm fan. This will insure increased stability and lifespan of your Redline modules.
Recommended Platforms--- Mushkin tests all Redline memory modules on Athlon64 platforms. Furthermore, when running two modules, only Socket 939 platforms are validated to run at rated specifications/timings. We currently recommend and validate the Redline memory series on the DFI LanParty UT NForce4 Ultra-D, DFI LanParty UT NForce4 SLI-DR, and DFI LanParty NForce4 SLI-DR boards as they provide the best combination of voltage options and compatibility for the Redline Series. Other motherboards may work, but may require modification for adequate voltages, and may not produce optimal results. Single Channel Athlon64 systems may have a hard time running 2x512mb dimms at rated speeds due to memory load on the single channel memory controller. Pentium4 and AthlonXP systems generally will not obtain rated specifications secondary to motherboard/memory controller limitations. These modules are compatible with most motherboards for Pentium4/AthlonXP CPUs, however end users are advised that lower frequencies achieved.”
The XP4000 REDLINE belongs to Mushkin’s Extreme Performance Series. It consists of two matched 512mb modules specifically designed for use on dual channel systems. This dual pack is based on Winbond’s very famous UTT chips rated at ultra low latencies of 2-2-2. The detailed specs for the modules are listed below.
Specs
| Latency | | 2-2-2 |
| Frequency | | 500MHz |
| Parity | | Unbuffered |
| Voltage | | 3.3V-3.5V |
| Module Density | | 64Mx64 |
| Chip Density | | 32Mx8 |
| Pins | | 184 |
| Package | | Jet Black 6 Layer PCB |
| Heat Spreader | | Yes (color may vary) |
| Part # | | 991440 |